ADT® Authorized Dealer Serving Davenport & Entire Quad Cities Area
close up of a lady adjusting the security panel
March 01, 2022

How To Reset Your Security System In Davenport

A nice benefit of getting your home security installed by professionals is that you seldom have to concern yourself with it. With that being said, there will likely be a couple situations when you have to reset your alarms in Davenport. If you use a smart command panel, a reset normally requires just a few minor button tap following a false alarm, power outage, or battery change.

Consult Your Manual Before Trying to Reset Your Alarm Panel

One note of caution before you start resetting your Davenport home security system, check your owner’s manual first. You don't want to undermine your property’s defense because you hit something incorrectly. In addition, the process may be different if you moved from a numerical keypad to a modernized touchscreen interface. And if you’re unable to figure out how to reset your system, don't worry as you can always contact your trusted security specialists.

Resetting Your Davenport Home Security System After A False Alarm

Usually, a false alarm takes place as a result of a sensor that was tripped by accident. You may engage the ADT Command touchscreen or open the ADT mobile app and tap the shield option and submit your credentials to switch off the alarms in these situations. You could get a call from your security monitoring team, but just tell them you experienced a false alarm.

Tips To Reset Your Alarm When Experiencing A Power Outage In Davenport

When you lose power from a storm or other event, you could begin hearing a repeated, high-pitched beep from your control panel. That indicates that your home’s defense is being powered by the secondary power source. To reset your unit and silence the steady beeps, you must take steps to disarm and rearm your security.

Keep in mind, if power is out for prolonged time frame, you might need a total reset of your home’s security. Pay careful attention to the instructions in the instruction manual -- usually by putting in your code and tapping the off button two times -- and you should be back to normal. You may still hear chirps from the backup power, as it’s possible it won’t end until your battery reaches a full charge. Call your home security specialists if you keep having difficulties with your ADT system at least 20 hours after the power is resumed.

How To Reset Your Home Security System After Switching Out A Battery

There will be infrequent times when you need to change a battery powering one of your security devices. To do this, you should set your alarm system to test mode so you don't trigger an alarm by accident. When the you replace the old battery, move the alarm out of test mode and revert back to your usual settings. If the system fails to notice the piece of equipment or the battery indicator is still on, you may require a whole system reset.

Tips to Reset Your Davenport Security System Following The Addition Or Deletion Of A User

The addition and deletion of users can be done on the ADT Command panel and your ADT smartphone app. You should never have to perform a system reset when deleting or adding users. But you should note, if you move into a new property with an existing ADT system, you need to contact your security specialists at (563) 231-4633 to establish a new service. The technician will visit your property to replace outdated parts, place additional devices (if necessary), and reset the system for you.

An Easy-To-Use Security System Is Only A Call Away

Figuring out how to reset a home security system in Davenport can be a challenge if it fails to include user-friendly equipment and instructions. If the time has come to get your easy-to-use home security system, call (563) 231-4633 or send in the form below. Our team is happy to customize the ideal security system for your residence.